ST7SB Socket Board User Guide | 3 - Configuring and Connecting to Your Socket Board |
3.2Connect to the socket board
All ST7 programming tools that use a
The following sections tell you how to setup your socket board when:
•Connecting via the ICC cable (all programmers and emulators)
•Connecting via the female HE10 connector
3.2.1Connecting via the ICC cable
To connect to your socket board via ICC cable:
1Plug the ICC cable into the
2Set both POWER jumpers to the 2 position, as shown in Figure 4, inset B .
A
B
Figure 4: Power supply jumper positions
3Connect the power supply for both the socket board and the programming tool. Once connected, the green Power LED should light up and remain lit.
You are ready to program your ST7 from the STVP7 interface on your host PC.
7/12