Philips SV1 7.Troubleshooting

If a fault occurs, first check the points listed below before taking the projector for repair.

If you are unable to correct a problem by following these hints,consult your dealer or ser vice

center.

Under no circumstances should you try to repair the projector yourself as this could void your

warranty.

– Possible cause

•Solution

General

– Mains lead is not correctly connected.

•Check the mains lead connection.

– Lamp holder cover is not closed correctly or the lamp holder is damaged.

•Check cover for proper closure (see ‘Lamp replacement’under ‘Maintenance’).

– Signal cable not correctly connected.

•Check signal cable connection.

– The projector is in Off position.

•Press the Standby button to turn the projector on.

In Video series mode

– Keystoning is applied on a high resolution component signal.

•Decrease keystoning until the image is correctly displayed.

For this use the ‘Keystone’option in the ‘Setup’menu.

In Data mode

-- Partial,scrolling or incorrectly displayed image.

•Use the 'Auto Sync' option in the ‘Picture’menu.

– Input resolution is too high (and keystoning is applied).

•If you wish to keep the keystone correction, decrease the input resolution until the image is

correctly displayed.

For this, refer to the User Guide or support information of the computer.

•If you wish to keep the input resolution as it is,decrease keystoning until the image is

correctly displayed. For this,use ‘Keystone correction’option in the ‘Settings’menu.

– Input resolution is too high (and no keystoning is applied).

•Decrease the input resolution until the image is correctly displayed.

For this, refer to the User Guide or support information of the computer.

Problem

Philips Multimedia Projector 34 English User guide bCool SV1

7.Troubleshooting