Philips SV1 7.Troubleshooting

•Adjust ‘Brightness’,‘Contrast or ‘Colour tracking’(see ’Picture adjustment’under ‘Operation’-

‘On Screen Display Menu’).

•Reset all projector settings in the ‘Setup’menu (‘Factory settings’).

– Image is not focused.

•Adjust focus ring.

– Distance between projector and screen is not correct.

•Adjust the distance between the projector and the screen.

– Signal cable is not correctly connected.

•Check signal cable connection.

– Signal cable is not correctly connected.

•Check signal cable connection.

– Distance is too great.

•Reduce distance.

– Batteries are exhausted.

•Replace batteries (see ‘Inserting the batteries in the remote control’).

– IR sensor is obstructed.

•Remove obstacle.

Lamp indicator

–Red blinking (0.5sec. On,0.5sec. Off): lamp start has failed.

• Disconnect projector from the mains. Reconnect and restart. If this does not solve the

problem, replace the lamp.See ’Maintenance.’

–Red blinking (1sec. On,1sec. Off): the fans are locked.

• The projector will automatically shut down. If this problem continues,contact your Service

Center.

Temp.(temperature) indicator

–Lights up red: temperature error.

• Disconnect projector from the mains. Reconnect and restart.

If this does not solve the problem,contact your Ser vice Center.

Standby indicator (text on Standby button/ring around Standby button)

–Lights up green: Power on mode.

–Green blinking: warming up in Power on mode.

–Lights up red: Standby mode.

–Red blinking: cooling down in Power off mode.

Philips Multimedia Projector 35 English User guide bCool SV1

7.Troubleshooting