Philips T510 warranty Inserting The Batteries, To Insert Batteries, To Remove Batteries, Trimming

Inserting The Batteries

◗Your new Trimmer requires 2 “AA” 1.5 V alkaline or carbon zinc batteries.

To Insert Batteries

1Be certain Trimmer is in the OFF position.

2Hold Trimmer horizontally and press the release tabs located at base of Trimmer. Gently slide battery compartment out of Trimmer housing until it stops (fig. 1).

NOTE: Battery compartment is not removable.

3Insert the batteries as shown making sure the

(+) and (-) markings on the batteries match those on inside compartment ofTrimmer (fig.2).

4Slide the battery compartment back into Trimmer housing (fig. 3).

NOTE: Trimmer will not operate if batteries are inserted incorrectly. If you do not intend to use the appliance for a long time, remove the batteries. Leaking batteries can cause damage to the product.

To Remove Batteries

1Follow steps 1-2 above. Push the batteries out of the holder as shown (fig. 4).

Trimming

◗Use this Trimmer for its intended household use as described in this manual.

◗Always comb the beard and/or moustache with a fine comb before you start trimming.

◗If you are trimming for the first time, be careful. Do not move the Trimmer too fast. Make smooth and gentle movements.

Trimming with AccuControl

Guide Comb Attachment

◗Guide Comb Attachment must be on Trimmer in order to use the Hair Length Selector.

1Slide the Hair Length Selector to the desired trimming length setting (see table).The setting will appear in the window in the center of the Guide Comb attachment (fig. 5).

◗If you are trimming for the first time,start by using the maximum trimming length setting (#4) to prevent accidentally trimming hairs too short. As you become familiar with the settings,adjust Hair Length Selector to desired trimming length. Selector will “click” into position at each setting.

2Switch the Trimmer ON.

3To trim in the most effective way, move the Trimmer against the direction of hair growth. Make sure the surface of the Guide Comb always stays in contact with the skin (fig. 6).

NOTE: Since all hairs do not grow in the same direction, you may want to try different trimming positions (i.e., upwards, downwards, or across). Practice is best for optimum results.

4If cut hairs have accumulated in the

Guide Comb, turn Trimmer off, remove the Comb Attachment by adjusting it to setting #4 and then pull it off the Trimmer (fig. 7).

5Blow and/or shake the hair out of the comb (fig. 8). Replace the Guide Comb on Trimmer and adjust comb to the chosen setting.