Philips TDA2613

July 1994 4

Philips Semiconductors Product speciﬁcation

6 W hi-ﬁ audio power ampliﬁer TDA2613

FUNCTIONAL DESCRIPTION

This hi-fi power amplifier is designed for mains fed applications. The device is intended for asymmetrical power supplies,

but a symmetrical supply may also be used. An output power of 6 watts (THD = 0,5%) can be delivered into an 8Ω load

with an asymmetrical power supply of 24 V.

The gain is fixed internally at 30 dB. Internal gain fixing gives low gain spread.

A special feature of this device is a mute circuit which suppresses unwanted input signals during switching on and off.

Referring to Fig.4, the 100 µF capacitor creates a time delay when the voltage at pin 3 is lower than an internally fixed

reference voltage. During the delay the amplifier remains in the DC operating mode but is isolated from the non-inverting

input on pin 9.

Two thermal protection circuits are provided, one monitors the average junction temperature and the other the

instantaneous temperature of the power transistors. Both protection circuits activate at 150°C allowing safe operation to

a maximum junction temperature of 150 °C without added distortion.

RATINGS

Limiting values in accordance with the Absolute Maximum System (IEC 134)

Note to the Ratings

For asymmetrical power supplies (at short-circuiting of the load) the maximum supply voltage is limited to VP = 28 V.

If the total internal resistance of the supply (RS)≥4Ω, the maximum unloaded supply voltage is increased to 32 V.

For symmetrical power supplies the circuit is short-circuit proof to VP = ±21 V.

PARAMETER CONDITIONS SYMBOL MIN. MAX. UNIT

Supply voltage VP−42 V

Non-repetitive peak

output current IOSM −4A

Total power dissipation see Fig.2 Ptot

Storage temperature range Tstg −55 + 150 °C

Junction temperature Tj−150 °C

Short-circuit time: see note

outputs short-circuited

to ground

(full signal drive) tsc −1 hour