Phoenix Gold manual Technical Support, IAMP-GM1 Update Kit, Black and Blue/White wires

Technical Support

iAMP-GM1

2013 Update Kit

This kit provides a fix for the following instances:

West Coast	Corporate
Operations	Headquarters
1340 Ritchey Street	13190 56th court
Santa Ana, CA 92705	Clearwater, FL 33760
800-854-3133	800-477-2267
714-835-3233 (Fax)	727-573-9326 (Fax)

Technical Support 866-931-8021

Black and Blue/White wires:

In 2013 vehicles that are equipped with the My Link radios, the color display will not turn on.

In 2013 convertable vehicles that are equipped with the My Link radios, the radio has poor reception.

Brown and Brown/White wires:

In 2010-2013 vehicles manufactured for use outside of the US, the factory Bluetooth module no longer works.

**Vehicles located in the US will only need the Black wire and the Blue/White wire. No damage will be

done if all 4 wires are installed in either the US or Non-US models.**

Locate the plastic bag that houses the 4 wires needed for this modification. Remove the wires from the plastic bag. (See Figure A.)

Figure A.

Remove the factory radio to gain access to the iAMP-GM1 harness that is connected to the back of the radio and disconnect it. (If the harness from the iAMP-GM1 has not yet been installed

please disregard this last step.) Locate the male side of the harness (the side that plugs into the factory radio) and firmly grasp both sides of the white insert and pull forward so that the insert pops out approx. 1/8 inch. (see Figure B.)

Figure B. Figure C.

Locate pin #9 in the harness. It should be next to a brown/white wire. Insert the male end of the black wire into the opening. Push the pin in far enough that it locks

into the connector. (See Figure C.)

Phoenix Gold a division of AAMP of America -13190 56th Court, Clearwater, Florida 33760 - www.phoenixgold.com

Email - support@phoenixgold.com - Toll Free: 866-788-4237 - Fax: 800-444-6044

12-13-2012 T.T.