Amplifier Owner’s Manual
SPECIFICATIONS
FRONT AND REAR CHANNEL SPECIFICATIONS
Frequency Response: | ± 1dB from 20Hz to 20kHz |
Signal to Noise Ratio: | >110dB |
High and Low Pass Crossovers: | 18dB per octave |
Front High Pass Crossover Range: | 40Hz to 4kHz |
Rear High Pass Crossover Range: | 10Hz to 300Hz |
Rear Low Pass Crossover Range: | 40Hz to 4kHz |
Low Level Input Range: | 200 millivolts to 8 volts |
Lowest Recommend Load: | 4 ohm Bridged or 2 ohm Stereo |
Typical Efficiency: | 50% |
Damping Factor | Greater than 200 |
Dynamic Power 14.4Vdc >1% THD | 100 x 4 @ 4 ohm Stereo |
| 150 x 4 @ 2 ohm Stereo |
| 300 x 2 @ 4 ohm Bridged |
RMS Power 14.4Vdc ≤1% THD | 90 x 4 @ 4 ohm Stereo |
| 120 x 4 @ 2 ohm Stereo |
| 240 x 2 @ 4 ohm Bridged |
SUBWOOFER CHANNEL SPECIFICATIONS
Frequency Response: | ± 1dB from 20Hz to 300Hz |
Signal to Noise Ratio: | >90dB |
Subsonic and Low Pass Crossovers: | 24dB per octave |
Low Pass Crossover Range: | 30Hz to 300Hz |
Subsonic Crossover Range: | 10Hz to 55Hz |
Bass Boost @ 45Hz: | 0 to +18dB |
Low Level Input Range: | 200 millivolts to 8 volts |
Lowest Recommend Load: | 1 ohm |
Typical Efficiency: | 80% |
Damping Factor: | Greater than 200 |
Dynamic Power 14.4Vdc >1% THD | 800 x 1 @ 2 ohm |
| 1000 x 1 @ 1 ohm |
RMS Power 14.4Vdc ≤ 1% THD | 550 x 1 @ 2 ohm |
| 800 x 1 @ 1 ohm |
|
|
OVERALL SPECIFICATIONS
Recommended Fuse Size: | 150A |
Minimum Power/Ground Wire Size: | 1/0 Gauge |
Dimensions: | 28.2” L x 9.8”W x 2.5” H |
| 716mm x 252mm x 62mm |
© 2011 Phoenix Gold • www.phoenixgold.com
