TI1600.5 - OPERATIONAL DETAILS
FRONT/REAR/ SUB INPUT
Connect signal cables from the head unit to these terminals.
2ch/4ch/5ch INPUT SELECTOR
2ch: Headunit has one pair of cables into front Input.
4ch: Headunit has two pairs of cables into front and rear inputs.
5ch: Headunit has three pairs of cables into front, rear and sub inputs.
LEVEL
Used to reach maximum amplifier power with a wide variety of headunits.
FRONT AND REAR SPEAKER OUTPUTS
Used to connect the amplifier to speakers. Minimum impedance is 2 ohm stereo/4 ohm bridged. Use left channel + and right channel - for bridged mode.
HP/LP CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
CONFIG
FLAT/OFF: Crossovers are turned off
HP: High pass crossover is on
LP/BP: Low and High Pass crossovers are both on, creating a Bandpass (BP) setting for midbass drivers.
Notes: The front HP and rear LP crossovers extend to 4kHz, so its possible to run a component speaker system fully active. The tweeters would be powered by the front channels and the midbasses by the rear channels. Be sure to check with your speaker’s manufacture for the correct tweeter and midbass crossover points to avoid speaker damage.
Subwoofer channel LP crossover and subsonic filter are always on.
SUB CHANNEL SPEAKER OUTPUTS
Used to connect the amplifier to subwoofers. Minimum impedance is 1 ohm.
© 2011 Phoenix Gold • www.phoenixgold.com
