Pico Macom PR3200 manual Programming

PROGRAMMING

1.Plug the AC cord to an AC outlet and turn on the receiver.

2.If the receiver has not been pro-grammed for the last channel, the display shows "1" which indicates CH.1.

3.Normally, the receiver has been preset and factory programmed. See the preset Channel Table attached.

4.Select the channel number to be pro- grammed by using "+"/"-" keys

Video I.F. Frequency:

5.Start programming by pressing “SET” key. The first pressing of the “SET” key is for programming the video i.f. frequency. The display shows the reading of the i.f. frequency. Usually, the frequency shown is the preset frequency of this channel.

6.Program the i.f. frequency by using the “+”/”-” keys.

7.Press “+”/”-” keys once at a time, the frequency moves up/down in increments of 250KHz. The LED indicator on the right side of the main display indicates the changes. The display of the change would be carried to the main display every 1MHz.

8.Continue to press the “+”/”-” for more than one second. The rate of frequency increment/decrement will be sped up/down for faster programming.

Audio Mode/

Audio Carrier Frequency

9.Press the "SET" key again. The second pressing of the "SET" is for programming the audio sub-carrier frequency.

10.Normally, the audio mode is preset in MONAURAL and the audio sub-carrier. frequency is preset at 6.80MHz and is the

only mode that is currently operational. Dis- regard modes 2, 3, & 4.

MODE DISPLAY STATUS

1. A.6.80 MONO/6.80MHZ/ Wide Band

11.Use “MODE” key to select AUDIO MODE 1.

12.Use the "+"/"-" key to program the audio sub-carrier frequency.

13.Press "+"/"-" key. Each time the fre- quency moves up/down 10KHz.

14.Keep pressing the "+'/"-" key for more than one second. The rate of frequency incre- ment/decrement will be speed up/down for faster programming.

15.Press the set key again. This third press- ing of the "SET" key is to program the polar- ity. and LNB inputs. Currently, the only mode that is operational is MODE 1. Audio Sub-carriers from 5.0MHz to 8.0MHz can be accessed in this mode. Disregard MODES 2, 3 & 4.

MODE DISPLAY POLARTIY LNBINPUT

1. U. 1. Vertical 1.

Completion of Programming:

In SMATV application, automatic LAST channel set-up may be reqiired accidental power failure. The procedure for LAST chan- nel programming are as follows.

1.Select the number of the LAST channel. to used by using "+"/"-" keys.

2.Press "SET" key 4 times, and confirm all of the parameters as they are going through the display.

3.As soon as the display goes back to channel display, the LAST channel programming is completed.

9

PICO MACOM INC. 12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511