NEVER LEAVE A FAN
OPERATING UNATTENDED
Portable
Air Circulator
Installation | Belt Replacement (Continued) |
Simply locate fan in safe, desired position on level ground, and connect to approved power source.
Operation
This fan is equipped with a
TO START FAN:
1.Be sure the Power Switch is in the middle (OFF) position.
2.Connect to an approved power source.
3.Make sure area is clear from all obstructions.
4.Push Power Switch to the LOW position and allow to operate for 10 seconds.
5.Once 10 seconds have passed, you may now push the Power Switch to the HIGH position.
TO TURN OFF FAN:
1To turn off the fan, simply return Power Switch to the middle (OFF) position.
NOTE: For longer parts life, after 10 hours of continu- ous operation, turn fan off for 15 minutes to allow motor and fan belt to cool.
Maintenance and Storage
1.Inspect your fan before each use. Check all wires and extension cords, following the procedure outlined on Page 2 (Safety Information).
2.After use, always be sure fan’s Power Switch is in the OFF position before unplugging. Use cord wrap (see page 4) to keep cord off the ground when transporting fan.
Belt Tightening / Replacement
1.Remove screws from Rear Guard and tilt wheel (figure 1).
2.Loosen motor nuts, and motor safeguards (located above and below motor).
3.Remove belt to replace, or adjust motor to tighten belt (figure 2).
figure 1
figure 2
Wiring Diagram
Pinnacle Products International, Inc. Portable Air Circulator User’s Manual | Page 3 |
