The System Setup menu07
48
En
Manual speaker setup
This receiver allows you to make detailed
settings to optimize the surround sound
performance. You only need to make these
settings once (unless you change the
placement of your current speaker system or
add new speakers.).
These settings are designed to fine-tune your
system, but if you’re satisfied with the settings
made in
Automatically setting up for surround
sound (MCACC)
on page 12, it isn’t necessary
to make all of these settings.
1 Select ‘SP SETUP’ from the System Setup
menu then press
ENTER
.
See
Making receiver settings from the System
Setup menu
above.
2 Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
If you are doing this for the first time, you may
want to adjust these settings in order:
•
SP SET
– Specify the size and number of
speakers you’ve connected (see
Speaker
setting
below).
•
X.OVER
– Specify which frequencies will be
sent to the subwoofer (see
Crossover
network
on page 49).
•
CH LEVEL
– Adjust the overall balance of
your speaker system (see
Channel level
on
page 49).
•
SP DISTN.
– Specify the distance of your
speakers from the listening position (see
Speaker Distance
on page 50).
Speaker setting
Use this setting to specify your speaker
configuration (size, number of speakers). It is a
good idea to make sure that the settings made
in
Automatically setting up for surround sound
(MCACC)
on page 12 are correct.
1 Select
SP SET
from the SP SETUP menu.
2 Use
/
(cursor left/right) to choose the
speaker(s) that you want to set then select a
speaker size.
Use
/
(cursor up/down) to select the size
(and number) of each of the following
speakers:
•
Front
(
F
) – Select
LARGE
if your front
speakers reproduce bass frequencies
effectively, or if you didn’t connect a
subwoofer. Select
SMALL
to send the bass
frequencies to the subwoofer.
1
•
Center
(
C
) – Select
LARGE
if your center
speaker reproduces bass frequencies
effectively, or select
SMALL
to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect a center
speaker, choose
NO
(the center channel is
sent to the front speakers).
•
Surround
(
S
) – Select
LARGE
if your
surround speakers reproduce bass
frequencies effectively. Select
SMALL
to
send bass frequencies to the other
speakers or subwoofer. If you didn’t
connect surround speakers choose
NO
(the sound of the surround channels is
sent to the front speakers or a subwoofer).
•
Surround Back
(
SB
) – Select the number
and size of surround back speakers you
have. Select
LARGE
if your surround back
speakers reproduce bass frequencies
effectively. Select
SMALL
to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect surround
back speakers choose
NO
.
2
•
Subwoofer
(
SW) – LFE signals and bass
frequencies of channels set to SMALL are
output from the subwoofer when YES is
selected (see notes below). Choose the
PLUS setting if you want the subwoofer to
Note
1 If you select SMALL for the front speakers the subwoofer will automatically be fixed to YES. Also, the center, surround, and
surround back speakers can’t be set to LARGE if the front speakers are set to SMALL. In this case, all bass frequencies are sent
to the subwoofer.
VSX_815-915.book.fm 48 ページ ２００４年１２月８日 水曜日 午後４時３分