The System Setup menu 07
49
En
English Français
Deutsch
Nederlands
Italiano Español
output bass sound continuously or you
want deeper bass (the bass frequencies
that would normally come out the front and
center speakers are also routed to the
subwoofer). If you did not connect a
subwoofer choose
NO
(the bass
frequencies are output from other
speakers).
3 When you’re finished, press RETURN.
Tip
• If you have a subwoofer and like lots of
bass, it may seem logical to select
LARGE
for your front speakers and
PLUS
for the
subwoofer. This may not, however, yield the
best bass results. Depending on the
speaker placement of your room you may
actually experience a decrease in the
amount of bass due low frequency
cancellations. In this case, try changing
the position or direction of speakers. If you
can’t get good results, listen to the bass
response with it set to
PLUS
and
YES
or the
front speakers set to
LARGE
and
SMALL
alternatively and let your ears judge which
sounds best. If you’re having problems, the
easiest option is to route all the bass
sounds to the subwoofer by selecting
SMALL
for the front speakers.
Crossover network
• Default setting:
100Hz
This setting decides the cutoff between bass
sounds playing back from the speakers
selected as
LARGE
, or the subwoofer, and bass
sounds playing back from those selected as
SMALL
.
1
It also decides where the cutoff will
be for bass sounds in the LFE channel.
1Select ‘
X.OVER’
from the SP SETUP menu.
2 Use
/
(cursor up/down) to choose the
frequency cutoff point.
Frequencies below the cutoff point will be sent
to the subwoofer (or
LARGE
speakers).
3 When you’re finished, press RETURN.
Channel level
Using the channel level settings, you can
adjust the overall balance of your speaker
system, an important factor when setting up a
home theater system.
1 Select
CH LEVEL
from the SP SETUP menu.
2 Use
/
(cursor up/down) to select a
setup option.
•
T. TONE M.
– Move the test tone manually
from speaker to speaker and adjust
individual channel levels.
•
T. TONE A.
– Adjust channel levels as the
test tone moves from speaker to speaker
automatically.
3 Confirm your selected setup option.
The test tones will start after you press
ENTER
.
4Adjust the level of each channel using the
/
(cursor up/down) buttons.
If you selected
T. TONE M.
, use
/
(cursor
left/right) to switch speakers.
The
T. TONE A.
setup will output test tones in
the following order (depending on the speaker
setting):
Note
2• If the surround speakers are set to
NO
, the surround back speakers will automatically be set to
NO
.
• If you selected
SB 2ND Z
or
SB BIAMP
(in
Surround back speaker setting
on page 43) you can’t adjust the surround back
settings.
• If you select one surround back speaker only, make sure that speaker is hooked up to the left surround back terminal.
1 For more on selecting the speaker sizes, see
Speaker setting
above.
LC
SBR
RS
R
LS
SW SBL
VSX_815-915.book.fm 49 ページ ２００４年１２月８日　水曜日　午後４時３分