![](/images/new-backgrounds/1296127/29612717x1.webp)
Installation
Note:
•Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections are correct and the system works properly.
•Use only the parts included with the unit to ensure proper installation. The use of unautho- rized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifica- tions of the vehicle.
•Install the unit where it does not get in the dri- ver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•Do not place the display in a position where it will impede the driver’s visibility or affect the operation of your vehicle’s air bags.
•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
•If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. (Fig. 8)
30°
Fig. 8
•When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.
•The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifires to radiate freely. (Fig. 9)
Do not close this area.
Fig. 9
15
•When mounting the
•Do not mount the
•Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts.
•If the
•If the
Installing the hide-away unit
Mounting with Brackets
Tapping screw (4 ⋅ 12 mm)
Carmat or chassis | Screw | |
Bracket | ||
(4 ⋅ 8 mm) |
Drill 2 to 2.5 mm diameter holes.
Fig. 10
Mounting with Velcro Tape
Thoroughly wipe off the surface before affixing the velcro tape.
Velcro tape (large) (hard)
Velcro tape (large) (soft)
Car mat or chassis
Fig. 11
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
Before installing the unit
•Remove the frame and the hold- er. (Fig. 12)
Pull out to remove the frame and then loosen the screws (2 ⋅ 3 mm) to remove the holder. (When reattaching the frame, point the side with a groove downwards and attach it.)
Holder
Screw (2 ⋅ 3 mm)
Frame
Fig. 12
DIN Front-mount
Installation with the rubber bush | English | |
| ||
1. Decide the position of the side |
| |
brackets. (Fig. 13) |
| |
When installing in a shallow space, | Español | |
change the position of side brackets. In | ||
| ||
this case, stick conceal tape on parts |
| |
that protrude from the dashboard. |
| |
| Deutsch | |
Conceal tape | Français | |
Side bracket | ||
| ||
Flush surface screw (5 ⋅ 6 mm) |
| |
Fig. 13 |
| |
| Italiano | |
| Nederlands | |
| PyÒÒÍËÈ |
16