Operating this unit

Section

02

A. ANSR (automatic answering)

1Press M.C. to turn automatic answering on or off.

R.TONE (ring tone select)

1Press M.C. to turn the ring tone on or off.

PB INVT (phone book name view)

1Press M.C. to switch between the lists of names.

Audio adjustments

1Press M.C. to display the main menu.

2Turn M.C. to change the menu option and press to select AUDIO.

3Turn M.C. to select the audio function. After selecting, perform the following proce- dures to set the audio function.

FAD/BAL (fader/balance adjustment)

1Press M.C. to display the setting mode.

2Press M.C. to cycle between fader (front/rear) and balance (left/right).

3Turn M.C. to adjust speaker balance.

!When the rear output and RCA output setting are SW, you cannot adjust front/rear speaker balance. Refer to REAR-SP (rear output setting) on the next page. Refer to PREOUT (preout setting) on the next page.

PRESET EQ (equalizer recall)

1Press M.C. to display the setting mode.

2Turn M.C. to select the equalizer.

DYNAMIC—VOCAL—NATURAL—CUSTOM— FLAT—POWERFUL

3Press M.C. to confirm the selection.

TONE CTRL (equalizer adjustment)

!Adjusted equalizer curve settings are stored in

CUSTOM.

1Press M.C. to display the setting mode.

2Press M.C. to select BASS (bass)/MID (mid)/TRE- BLE (treble).

3Turn M.C. to adjust the level. Adjustment range: +6 to –6

LOUD (loudness)

Loudness compensates for deficiencies in the low-frequency and high-frequency ranges at low volume.

1Press M.C. to select the desired setting. OFF (off)—LOW(low)—HI (high)

SUB.W (subwoofer on/off setting)

This unit is equipped with a subwoofer output which can be turned on or off.

1Press M.C. to select the desired setting.

NOR (normal phase)—REV (reverse phase)—OFF (subwoofer off)

SUB.W CTRL (subwoofer adjustment)

The cut-off frequency and output level can be adjusted when the subwoofer output is on.

Only frequencies lower than those in the selected range are outputted from the subwoofer.

!When you select OFF in SUB.W, you cannot select this function. For details, refer to SUB.W (subwoo-

fer on/off setting) on this page.

1Press M.C. to display the setting mode.

2Press M.C. to cycle between the cut-off frequency and output level of the subwoofer.

Cut-off frequency (Cut-off frequency display flashes.)—Output level (Output level display flashes.)

3Turn M.C. to select the desired setting.

Cut-off frequency: 50HZ—63HZ—80HZ—100HZ

—125HZ

Output level: –24 to +6

SLA (source level adjustment)

SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources.

!Settings are based on the FM volume level, which remains unchanged.

!The MW/LW volume level can also be adjusted with this function.

!When selecting FM as the source, you cannot

switch to SLA.

1Press M.C. to display the setting mode.

2Turn M.C. to adjust the source volume. Adjustment range: +4 to –4

3Press M.C. to confirm the selection.

unit this Operating

En

17