Section

02Operating this unit

 

Section

Operating this unit

02

Note

When this unit’s blue/white lead is connected to the vehicle’s auto-antenna relay control terminal, the vehicle’s antenna extends when this unit’s source is turned on. To retract the antenna, turn the source off.

Use and care of the remote control

Using the remote control

1Point the remote control in the direction of the front panel to operate.

When using for the first time, pull out the film protruding from the tray.

Replacing the battery

1Slide the tray out on the back of the remote con- trol.

2Insert the battery with the plus (+) and minus (–) poles aligned properly.

!If the battery leaks, wipe the remote control completely clean and install a new battery.

!When disposing of used batteries, comply with governmental regulations or environmen- tal public institutions’ rules that apply in your country/area.

!“Perchlorate Material – special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/ perchlorate. (Applicable to California, U.S.A.)”

Important

!Do not store the remote control in high tem- peratures or direct sunlight.

!The remote control may not function properly in direct sunlight.

!Do not let the remote control fall onto the

floor, where it may become jammed under the brake or accelerator pedal.

Menu operations identical for function settings/audio adjustments/initial settings/lists

Tuner

2 Turn M.C. to change the menu option

English

Basic Operations

and press to select FUNCTION.

3 Turn M.C. to select the function.

 

 

Selecting a band

 

After selecting, perform the following proce-

 

1 Press B (BAND/ESC) until the desired band (F1,

 

dures to set the function.

 

F2, F3 for FM or AM) is displayed.

 

 

 

 

 

BSM (best stations memory)

 

Manual tuning (step by step)

 

 

1 Press c or d.

 

BSM (best stations memory) automatically stores the

 

 

 

 

Seeking

 

six strongest stations in the order of their signal

 

 

strength.

 

1 Press and hold c or d, and then release.

 

 

 

1 Press M.C. to turn BSM on.

 

You can cancel seek tuning by briefly pressing c

 

 

 

To cancel, press M.C. again.

 

or d.

 

 

 

 

 

While pressing and holding c or d, you can skip

 

LOCAL (local seek tuning)

 

stations. Seek tuning starts as soon as you re-

 

Local seek tuning lets you tune in to only those radio

 

lease c or d.

 

 

 

stations with sufficiently strong signals for good re-

 

 

 

 

 

 

 

 

 

ception.

 

Storing and recalling stations

1 Press M.C. to display the setting mode.

 

2 Turn M.C. to select the desired setting.

 

for each band

FM: OFF—LEVEL 1—LEVEL 2—LEVEL 3—LEVEL

 

4

 

 

 

 

Using preset tuning buttons

AM: OFF—LEVEL 1—LEVEL 2

 

1 When you find a station that you want

The highest level setting allows reception of only

 

the strongest stations, while lower levels allow the

 

to store in memory, press one of the preset

reception of weaker stations.

 

tuning buttons (1 to 6) and hold until the

3 Press M.C. to confirm the selection.

 

preset number stops flashing.

 

 

2 Press one of the preset tuning buttons

 

 

WARNING

!

Keep the battery out of the reach of children.

 

Should the battery be swallowed, consult a

 

doctor immediately.

!

Batteries (battery pack or batteries installed)

Returning to the previous display

Returning to the previous list (the folder one level higher)

1Press .

Returning to the main menu

Returning to the top tier of list

(1 to 6) to select the desired station.

CD/CD-R/CD-RW and USB

# You can also recall stored radio stations by

pressing a or b during the frequency display.

storage devices

Basic Operations

Switching the display

must not be exposed to excessive heat such

as sunshine, fire or the like.

CAUTION

!Use one CR2025 (3 V) lithium battery.

!Remove the battery if the remote control is not used for a month or longer.

!There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

!Do not handle the battery with metallic tools.

!Do not store the battery with metallic objects.

1Press and hold .

Returning to the ordinary display

Canceling the initial setting menu

1Press B (BAND/ESC).

Returning to the ordinary display from the list 1 Press B (BAND/ESC).

Selecting the desired text information

1Press .

Program service name—song title—artist name

Scrolling the song title/artist name information to the left

1Press and hold .

Note

Depending on the area, you cannot switch the display.

Function settings

1 Press M.C. to display the main menu.

Open the front panel

1Press the open button. Disc loading slot appears.

Playing a CD/CD-R/CD-RW

1Insert the disc into the disc loading slot with the label side up.

Ejecting a CD/CD-R/CD-RW

1Press h.

Playing songs on a USB storage device

1Open the USB connector cover and plug in the USB storage device using a USB cable.

Stopping playback of files on a USB storage device

1You may disconnect the USB storage device at any time.

6 En

En 7