Pioneer DEH-P350 Switching the dimmer setting, Setting the rear output and subwoofer controller, Initial Settings

1 PressFUNCTION to select AUX.
PressFUNCTION repeatedly until AUX ap-
pearsin the display.
2 Pressaor bto turn AUX on or off.
Pressingaor bwill turn AUX on or off and
thatstatus will be displayed (e.g.,
AUX:ON).
Switching the dimmer setting
Toprevent the display from being too bright at
night,the display is automatically dimmed
whenthe car s headlights are turned on. You
canswitch dimmer on or off.
1 PressFUNCTION to select DIMMR.
PressFUNCTION repeatedly until DIMMR ap-
pearsin the display.
2 Pressaor bto turn DIMMR onor off.
Pressingaor bwill turn DIMMR on or off
andthat status will be displayed (e.g.,
DIMMR:ON).
Setting the rear output and
subwoofer controller
Thisunits rear output (rear speaker leads out-
putand RCA rear output) can be used for full-
rangespeaker (R-SP :FUL) or subwoofer
(R-SP:S/W) connection. If you switch the rear
outputsetting to the R-SP :S/W, you can con-
necta rear speaker lead directly to a subwoo-
ferwithout using an auxiliar y amp.
Initially,the unit is set for rear full-range speak-
erconnection (R-SP :FUL). When rear output
areconnected to full range speakers (when
R-SP:FUL is selected), you can connect the
RCAsubwoofer output to a subwoofer. In this
case,you can select whether to use the sub-
woofercontroller s (low pass filter,phase)
built-inP/O :S/W or the auxiliary P/O:FUL.
1 PressFUNCTION to select R-SP.
PressFUNCTION repeatedly until R-SP ap-
pearsin the display.
2 Pressaor bto switch the rear output
setting.
Pressingaor bwill switch between
R-SP:FUL (full-range speaker) and R-SP :S/W
(subwoofer)and that status will be displayed.
#Whenno subwoofer is connected to the rear
output,select R-SP :FUL.
#Whena subwoofer is connected to the rear
output,set for subwoofer R-SP :S/W.
#Whenthe rear output setting is R-SP :S/W,
youcannot change the subwoofer controller.
3 Presscor dto switch the subwoofer
outputor non fading output.
Pressingcor dwill switch between P/O :S/W
andP/O :FUL and that status will be dis-
played.
Notes
!Evenif you change this setting, there is no
outputunless you turn the non fading output
(referto Using non fading output on page 31)
orsubwoofer output (refer to Using subwoofer
outputon page 30) in the audio menu on.
!Ifyou change the subwoofer controller, sub-
wooferoutput and non fading output in the
audiomenu return to the factory settings.
!Bothrear speaker leads output and RCA rear
outputare switched simultaneously in this
setting.
Initial Settings
En
34
Section
08
HHHHHHHHHHHHHH