Pioneer AVH-P5150DVD, RS-D7RII TS-T01RSII 120 W Max, TS-M01RSII 120 W Max, TS-W01RSII 300 W Max

Shallow mounting aluminum die-cast basket and large ø140 mm voice coil

RS-A9 600 W Max. Limited distribution

Digital Integrated Power Amplifier

ODR &

• 50 W × 4 (4 Ω)/75 W × 4 (2 Ω)/50 W × 2 + 150 W	—3-band L/R independent digital parametric
× 1 (4 Ω)/150 W × 2 (4 Ω) (continuous power)	equalizer (±12 dB/0.5 dB steps)
• 100 W × 4 (4 Ω)/100 W × 2 + 300 W × 1 (4 Ω)/	—5-mode preset memory
300 W × 2 (4 Ω) (max. power)	—Time alignment
• High-performance 32-bit floating binary point	—Digital listening position selector
type DSP	—Parametric bass/treble controls
• Built-in DSP (Digital Signal Processor) (FIR)	—Digital compression
—31-band L/R independent digital	—4-way L/R independent digital crossover
graphic equalizer (±12 dB/0.5 dB steps)	network (high/mid/low/subwoofer)

RS-A7	600 W Max. Limited distribution
Digital Power Amplifier
• 50 W × 4 (4 Ω)/75 W × 4 (2 Ω)/50 W × 2 +	• 100 W × 4 (4 Ω)/100 W × 2 + 300 W × 1 (4 Ω)/
150 W × 1 (4 Ω)/150 W × 2 (4 Ω)	300 W × 2 (4 Ω) (max. power)
(continuous power)	• 2 optical digital inputs

—Crossover frequency:

20 Hz to 20,000 Hz (variable) —Crossover slope: 0 dB

to –72 dB

• 1 optical digital input
• 3 optical digital outputs		RS-A9
(mid/low/subwoofer)
		SHARC® DSP chip
	Common Features	• Gold-plated large screw-type power/
	• Bridgeable 4/3/2-channel capability	ground terminals
	• Current feedback amplifier	• Low load impedance capability
	• Full balanced system (bridgeable	(4 Ω, 2 Ω to 8 Ω allowable)
	connection)	• Copper-plated chassis
	• Multi 24-bit Burr Brown D/A converters	• L/R independent power supply
	• IP-Bus input/output	• Sound master clock
	• Gold-plated screw-type speaker terminals	• DAC volume

Pure Component

Caution: To avoid damaging your amplifier/subwoofer system, please make sure that the continuous power output of the amplifier is lower than the nominal power handling of the subwoofer.

Systems

TS-T01RSII 120 W Max.

3.5 cm Component Tweeter

•3.5 cm tweeter with ion-plated DLC (Diamond-like Carbon)-coated dual arc ring diaphragm

•High-performance magnetic circuit features lightweight aluminum voice coil with neodymium magnet

•Zinc die-cast frame

•Tungsten cone holder with anti-resonance structure

•Aluminum die-cast mounting bracket included

•Gold-plated large screw-type terminals

•Use with UD-N01RSII 2-Way Passive Crossover Network

•Maximum input: 120 W

•Nominal input: 50 W

TS-M01RSII 120 W Max.

17 cm Component Mid-Bass Speaker

•17 cm cone mid-bass speaker with multiple pulp fiber composite diaphragm

•Ion-plated DLC (Diamond-like Carbon)-coated titanium center cap

•Corrugated surround with damped coating on front and back edges

•High-Transient Short Voice magnetic circuit features copper ribbon short voice coil with neodymium magnet

•Bottom hold design zinc die-cast one-piece chassis

•Tungsten damper holder with anti-resonance structure

•Gold-plated large screw-type terminals

•Use with UD-N01RSII 2-Way Passive Crossover Network

•Maximum input: 120 W

•Nominal input: 50 W

UD-N01RSII

2-Way Passive Crossover Network

• Use with TS-M01RSII and TS-T01RSII

TS-S01RSII	50 W*/60 W** Max. ** With back chamber
	* With speaker unit only

7.7 cm Component Midrange Speaker

•7.7 cm cone midrange speaker with multiple pulp fiber composite diaphragm

•Ion-plated DLC (Diamond-like Carbon)-coated titanium center cap

•Corrugated surround with damped coating on front and back edges

•High-Transient Short Voice magnetic circuit features copper ribbon short voice coil with neodymium magnet

•Bottom hold design zinc die-cast one-piece chassis

•Tungsten damper holder with anti-resonance structure

•Zinc die-cast back basket

•Gold-plated large screw-type terminals

•Maximum input: 50 W*/60 W**

•Nominal input: 15 W

TS-W01RSII 300 W Max.

25 cm (10") Component Subwoofer

•25 cm cone woofer with multiple pulp fiber composite diaphragm and integrated center cap

•Space-saving small-enclosure-type design (recommended enclosure:

14 l to 28 l/0.49 cu.ft. to 0.99 cu.ft.)

•Corrugated fiber surround with damped coating on front and back edges

•Large-sized ø140 mm voice coil with multiple neodymium magnets

•Shallow mounting aluminum die-cast basket

•Gold-plated large screw-type terminals

•Maximum input: 300 W

•Nominal input: 150 W

Large ø140 mm Voice Coil High-Quality Mid-Bass Speaker

TS-W01RSII

The TS-W01RSII’s magnetic circuit structure uses a voice coil with large ø140 mm diameter to drive the center part of the entire speaker cone to improve transient.

Multiple neodymium magnets creating powerful magnetic flux help drive the cone with exceptional strength and accuracy.

The large vent in the center of the speaker back is maximized for fine control to reduce air resistance. The result: more accurate bass reproduction.

Compact Enclosure

We design our subwoofer cones for compact (14 to 28 liters) speaker enclosures.

Dual Arc Ring Tweeter Diaphragm

TS-T01RSII

TS-M01RSII

Ion-plated DLC (Diamond-like Carbon)-coated titanium center cap is superior in rigidity, and concave to suppress resonance in the magnetic circuit.

High-Transient Short Voice magnetic circuit achieves excellent sound linearity from high to mid-range and features a high number of turns of wire in the short lightweight voice coil (for voice coil drivability that is 15 % better than its predecessor).

Corrugated surround with damped coating on front and back edge effectively absorbs unwanted vibration, achieves excellent linearity and reduces interference of cone and surround.

Corrugated surround

The TS-T01RSII’s Dual Arc Ring Diaphragm, based on Pioneer’s	frequencies are mixed to achieve smooth characteristics
Super Wide Range Tune innovation, reliably reproduces clear	for superior sound reproduction. The light diaphragm has
sound audible up to super-high 48 kHz frequency.	a surface that is ion-plated with DLC (Diamond-like Carbon)
The inside and outside of the center drive-type ring	coating for extra rigidity and minimal distortion. 35 mm in	Dual arc ring diaphragm
diaphragm are shaped differently from each other, and	diameter, the diaphragm also contributes to excellent low
vibrate to varying degrees for various frequencies. These	frequency reproduction and precise, accurate sound staging.

35