Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Use MULTI-CONTROL to select
Subwoofer1.
Subwoofer1 appears in the display.
#You can also select the subwoofer setting
menu by pressing SW on the unit.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
ON appears in the display. Subwoofer output
is now on.
#To turn subwoofer output off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select stereo or monaural.
Push MULTI-CONTROL left to select monaural
and MONO appears in the display. Push
MULTI-CONTROL right to select stereo and
STEREO appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select
Subwoofer2.
Subwoofer2 appears in the display.
#You can also select the subwoofer setting
menu by pressing SW on the unit.
#When the subwoofer output is on, you can se-
lect Subwoofer2.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125—160—200 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time MULTI-CONTROL is pushed up or
down, subwoofer level increases or decreases.
+6 to –24 is displayed as the level is increased
or decreased.

Adjusting low pass filter

attenuation slope

When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1 Use MULTI-CONTROL to select
Subwoofer3.
Subwoofer3 appears in the display.
#You can also select the subwoofer setting
menu by pressing SW on the unit.
#When the subwoofer output is on, you can se-
lect Subwoofer3.
2 Push MULTI-CONTROL up or down to
select the phase of subwoofer output.
Push MULTI-CONTROL up to select normal
phase and appears in the display. Push
MULTI-CONTROL down to select reverse
phase and appears in the display.
3 Push MULTI-CONTROL left or right to
select slope.
Each time MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–18—–12—–6(dB/oct.)
Audio Adjustments
En
58
Section
13