3 Turnthe ignition switch to ON or ACC.
Ifthe car s air conditioner or heater is turned
on,turn it off. Noise from the fan in the air
conditioneror heater may prevent correct auto
TAand EQ.
#PressSOURCE to turn the source on if this
unitis turned off.
4 Selectthe position for the seat on
whichthe microphone is placed.
Referto Using the position selector on page 7.
#Ifno position is selected before you start auto
TAand EQ, FL is selected automatically.
5 PressSOURCE and hold until the unit
turnsoff.
6 Pressand hold EQ to enter the autoTA
andEQ measurement mode.
7 Plugthe microphone into the micro-
phoneinput jack on this unit.
8 Pressato start the auto TA and EQ.
9 Getout of the car and close the door
within10 seconds when the 10-second
count-downstarts.
Themeasurement tone (noise) is outputted
fromthe speakers, and auto TA and EQ be-
gins.
#Whenall speakers are connected, auto TA
andEQ is completed in about six minutes.
#Tostop auto TA and EQ, press any keys.
#Tocancel auto TA and EQ part way through,
pressBAND/ESC.
10 Whenauto TA and EQ is completed,
COMPLETEis displayed.
Whencorrect measurement of car interior
acousticcharacteristics is not possible, an
errormessage is displayed. (Refer to Under-
standingauto TA and EQ error messages on
page21.)
11 PressBAND/ESC to cancel theauto TA
andEQ mode.
12 Storethe microphone carefully in the
glovecompartment.
Storethe microphone carefully in the glove
compartmentor any other safe place. If the
microphoneis subjected to direct sunlight for
anextended period, high temperatures may
causedistortion, color change or mal-
function.
Using the equalizer
Theequalizer lets you adjust the equalization
tomatch car interior acoustic characteristics
asdesired.
Digital Signal Processor
En
16
Section
03