Audio Adjustment <Network>
Adjusting the Filter
First, determine the approximate band to be used, taking into consideration the reproduced frequency band and the characteristics of the connected speaker.
1.Open the cover of the remote controller in the Network Menu (refer to page 5).
This switches to Network Menu Setting Screen.
2.Press the FUNCTION button 1.
The display switches to Filter Adjustment Screen, allowing filter adjustments.
3.Press FUNCTION button 6 and select left (Left) or right (Right) channel (only for LR/IND mode).
Each press the FUNCTION button 6 switches left and right channel.
4.Press FUNCTION buttons 1 or 2 and select the filter to be adjusted.
Press the button to switch the band to be adjusted and high pass filter/low pass filter.
5.Press the 2/3 buttons to set up
the
Holding down these buttons continues their operations.
6.Set up the
Repeat steps 4 and 5 to adjust each filter so that the band used and crossover frequency are appropriately located.
Important points in adjusting
•If the subwoofer is installed in the rear tray, setting a high
•Speakers used for mid and
Important points in adjusting the level
•The low band, because of its sound frequency characteristics, incorporates the basic frequencies of many musical instruments. It is recommended that the level adjustment of the low band be made first, and then the level adjustment of the mid, high, and subwoofer be made in that order.
35