To start playback using the crossfader

1Set [THRU, ,] (the crossfader curve selector switch) J to [] or [].

2Press the [CH-1] or [CH-2] button I in the fader start section.

Turn the fader start function on.

3 Move the crossfader F.

Move the crossfader to the opposite edge from the channel for which you want to use the fader start function.

4 Set the cue on the DJ player.

The DJ player pauses playback at the cue point.

5 Move the crossfader F.

Playback starts on the DJ player.

!If you set the crossfader back to the original position, the player instantaneously returns to the cue point already set and pauses playback (back cue).

Monitoring the sound over headphones (headphones section)

HEADPHONES

CH-1 CH-2

5

MIXING

6

CUE MASTER

LEVEL

7

0

8

PHONES

1 Connect headphones to the [PHONES] terminal.

For instructions on connections, see Connecting the input/output terminals on page 7.

2Press the [CH-1] or [CH-2] button 5 in the headphones section.

Select the channel you want to monitor.

—[CH-1]: The sound of [CH-1] is monitored.

—[CH-2]: The sound of [CH-2] is monitored.

!This operation is not necessary to monitor the [MASTER 1] or [MASTER 2] (master channel) sound.

3Turn the [MIXING] control 6.

—When turned counterclockwise: The volume of [CH-1] and [CH-2] becomes relatively louder.

—Center position: The volume of the [CH-1] and [CH-2] sound is the same level as the [MASTER 1] and [MASTER 2] sound.

—When turned clockwise: The volume of [MASTER 1] and [MASTER 2] become relatively louder.

4Turn the [LEVEL] control 7 in the headphones section clockwise.

Sound is output from the headphones.

!When the [CH-1] or [CH-2] button in the headphones section is pressed again, monitoring is canceled.

![MASTER 1] and [MASTER 2] monitoring cannot be canceled.

Using a microphone or external device (MIC/AUX section)

MIC/AUX

MIC OFF AUX 1

AUX 2

2

AUX 3

LEVEL

3

0

HI

12 12

4 LOW

12 12

1Switch the [MIC, OFF, AUX 1, AUX 2, AUX 3] input selector switch 2.

—[MIC]: The microphone connected to the [MIC] terminal is selected.

—[AUX1–3]: Selects the external device connected to the [AUX1–3] terminals.

2Turn the [LEVEL] control 3 in the MIC/AUX section clockwise.

The sound of the microphone or external device is output from the speakers.

Adjusting the sound quality

Turn the [HI] or [LOW] control 4 in the MIC/AUX section.

Refer to Specifications on page 15 for the range of sound that can be adjusted by each control.

English

En 13