Attaching Pioneer CD-ROM Drives to Computers Running Windows95
August 1995
Windows95 operating system contains built in drivers for Pioneer's
Installing a Pioneer CD-ROM Drive
Note: If a Pioneer
The follow these steps to use your Pioneer
1.If you are newly installing a SCSI controller card, Windows95 should automatically detect the card on boot up. See the Windows95 User's Manual for information about installing new cards. Also, refer to Troubleshooting, point #1 in this document.
2.After you have confirmed that the SCSI controller card is properly installed, power down the Pioneer
3.If the Pioneer drive is the last devicve in the SCSI chain, make sure it is terminated.
Note: All units can be easily terminated by using an External Terminator Block and turning the internal termination switch OFF.
If the Pioneer Drive is in the middle of the SCSI Chain, make sure termination is OFF. The last device on the SCSI chain and the SCSI controller card must be terminated. If you also have an internal SCSI device connected to the controller, disable termination on the controller.
4.Verify that each SCSI device is set to a unique SCSI ID address.
5.Power ON the Pioneer
6.Power ON the computer running Windows95.
7.On