63
For Proper and Long Use ofThis Unit

DO NOT MOVE THE UNIT DURING PLAYBACK

During playback, the disc rotates at high speed. Do NOT
lift or move the unit during playback. Doing so may
damage the disc.

WHEN MOVING THE UNIT

When changing places of installation or packing the unit
for moving, be sure to remove the disc and return the
disc table to its original position in the player. Turn off the
player and unplug the power cord from the wall outlet in
a manner appropriate for your player model as follows.
(U.S. and Canadian models) Press STANDBY/ON to
switch the power to standby. Check that the “–OFF–”
indication in the display goes off, then disconnect the
power cord.
(Other models) Press on the remote control to switch
the power to standby checking that the “–OFF–”
indication in the display goes off. Press POWER on
the front panel to turn the player off, and then
disconnect the power cord.
Moving this unit with the disc loaded may result in
damage to this unit.

INSTALLATION

• Select a stable place to the side of a TV set or stereo
system to be connected to the unit.
• When using the unit with a stereo system, install the
speakers a little bit away from the TV.
• Do NOT install the unit on top of a TV or color monitor.
Install the unit away from equipment that may be
affected by magnetism, such as a cassette deck.
• Do NOT place objects on top of the unit.

AVOID INSTALLING IN A PLACE THAT IS:

• Exposed to direct sunlight
• Exposed to humidity or where ventilation is poor
• Extremely hot or cold
• Exposed to vibration
• Exposed to dust
• Exposed to oily smoke, steam or heat (for example, a
kitchen)

DO NOT BLOCK VENTS

Do NOT use the player on top of a long-fibered carpet,
bed or sofa, and do not cover it with a cloth, etc. This
will prevent heat radiation and could result in damage.

AVOID HEAT

Do NOT place the unit on equipment which generates
heat, such as an amplifier.
When installing the unit in a rack, place it on the lowest
shelf possible (however, not where it is exposed to dust)
and separated from the amplifier to avoid the heat
generated by the amplifier or other audio equipment.

CONDENSATION

Moisture may form in the operating section of the player
if the player is brought from cool surroundings into a
warm room or if the temperature of the room rises
suddenly. When this happens, the player’s performance
will be impaired.
To prevent this, let the player stand in its new
surroundings for about an hour before switching it on, or
make sure that the room temperature rises gradually.
Condensation may also form during the summer if the
player is exposed to the breeze from an air conditioner.
In such cases, change the location of the player.

SWITCH POWER TO STANDBY (OR OFF)

WHEN NOT USING THE UNIT

Depending on the strength of the TV or radio broadcast
signal, having the TV or radio on while power to the unit
is on may result in stripes on the TV screen or noise.
However, this is not a malfunction of this unit or the TV
or radio. In such a case, switch the power of the unit to
standby (off).

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords.
The power cords should be routed in such a way that
they are not likely to be stepped on. A damaged power
cord can cause a fire or give you an electrical shock.
Check the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized service
center or your dealer for a replacement.

CAUTION: WHEN PLACING THE UNIT IN A

STEREO RACK WITH GLASS DOORS

Be sure there is ample space between the unit and
the glass doors when opening the disc table using
the remote control. If the disc table opens against
strong resistance, such as a closed glass door,
damage to the unit may result.
ADDITIONAL
INFORMATION