<DRC1126>
En
11
CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE
WARNING
The power supply of the personal computer must be turned off before
cables are connected.

Fig. 5

When no SCSI hard disk or other SCSI equipment is used, connect according to the
following connection method.
Turn off the power supply of the personal computer.
Set the SCSI ID number.
Enable internal SCSI termination (switch #5 = ON).
Connect the power supply cable from the personal computer. At the time of
connection, please pay attention to the cable polarity.
Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI
connector is connected correctly to pin 1 of the cable.
When a sound board is used, connect the audio output with an audio cable to the
sound board.
Pin 1
Power Cable
SCSI
Interface
Cable
Audio Cable
SCSI HOST
Adapter
Sound Board
To the power supply of
the personal computer
Into an expansion slot of
the personal computer