Recording 06
51
En
•Use the
and
buttons to switch VPS/PDC
On
or
Off
.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the PlusCode programming
number that you entered), the recorder will prompt
you to enter the channel number that the TV program
is showing on.
Tip
• You can check the timer program settings by
pressing
TIMER REC
to display the timer recording
screen.
You can enter a PlusCode programming number when
the recorder is in standby.
Important
• You can’t use this feature until you have set up the
guide channels. See
Set VIDEO Plus+ CH
on page 81.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1Press ’VIDEO Plus+’.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode
programming number.
2 Use the number buttons to enter the PlusCode
programming number.
• To clear the last digit entered, press
CLEAR
.
•Use the
PREV
/
NEXT
button to switch VPS/
PDC on/off. With VPS/PDC on, the front panel VPS/
PDC indicator lights. (Note that a maximum of 8
timer recordings can be set with VPS/PDC on.)
3Press ENTER.
The display shows the timer settings:
Date
Start time
End time
Recording channel.
• If
CODE ERROR
appears in the display, check that
the PlusCode programming number is correct and
that the guide channel is set (see
Set VIDEO Plus+
CH
on page 81), then set the timer recording again.
• If
CAN’T SET
appears in the display, it means that
although you entered a valid PlusCode programming
number, the program has already finished.
You can extend a timer recording beyond the
programmed end time in two different ways. This can be
useful if a broadcast program overruns, for example.
ENTER
CLEAR
PREV NEXT
VIDEO Plus+
PLUSCODE
29324
HOME
MENU
ENTER
CLEAR
REC
PREV NEXT
STOP REC
TIMER REC
DVR-04_UK.book 51ページ ２００４年４月１１日 日曜日 午後５時２０分