Pioneer SX-SW260 Connecting up, English, 2Assemble the AM loop antenna, 4Connect each speaker

Connecting up 02

1Connect the display unit to the receiver subwoofer. Plug the L-shaped end of the display cable into the connector on the rear of the display unit, then plug the other end of the display cable into SYSTEM CONNECTOR jack on the receiver subwoofer.

2Assemble the AM loop antenna.

a

b

c

a. Bend the stand in the direction indicated by the arrow.

b. Clip the loop onto the stand.

c. If you want to fix to a wall or other surface, perform step b after first securing the stand with screws.

It is recommended that you determine the reception strength before securing the stand with the screws.

3Connect the AM and FM antennas1.

a.Connect one wire of the AM loop antenna to each AM antenna terminal2.

For each terminal, press down on the tab to open; insert the wire, then release to secure.

4Connect each speaker.

•Each speaker cable has a color-coded connector at one end and two wires at the other end.

Color-coded wire

(Connect to speaker)

Color-coded connector (Connect to rear panel)

•Twist and pull off the protective shields on each wire.

•Connect the wires to the speaker. Match the colored wired with the color-coded label (model label), then insert the colored wire into the red (+) side and the other wire into the black (–) side.

•Connect the other end to the color-coded speaker terminals on the rear of the receiver subwoofer. Make sure to insert completely.

The small lug at the wire-end of the speaker plug should face up or down depending on whether it’s being plugged into one of the upper or lower speaker terminals. Please make sure to connect correctly.

English

1

2

Upper terminal Lower terminal

b. Push the FM antenna3 plug onto the center pin of the FM antenna socket.

5Connect the subwoofer cable.

•Just below the subwoofer speaker, to the left of center, you should see the subwoofer connecting cable. Plug this into the SUBWOOFER SPEAKER terminal.

Note

1 • Keep antenna cables away from other cables, the display unit and receiver subwoofer.

•If reception with the supplied antenna is poor, see Improving poor FM reception and Improving poor AM sound on page 23 or Connecting external antennas on page 27.

2 • Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.

• The signal earth ( ) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth.

•If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.

•For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.

3 • To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.

11

En