Connecting the Unit

Two Amplifier (Ex. Bridge)

 

 

 

 

 

 

Connect to a car stereo.

MODE SELECT switch must

 

 

 

 

 

 

For details, see the

 

 

SYNC OUT

“Connection Diagram”.

be in MASTER position.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Connecting wire with RCA

2 Ω to 16 Ω

Connecting speaker wire

pin plugs (sold separately).

(sold separately).

 

MODE SELECT

 

SYNC IN

 

 

switch must be

 

 

in SYNC INV

 

 

position.

 

 

•Only use speakers having an impedance of 2 Ω to 16 Ω. In addition, in the case of connecting multiple speakers with a bridge, check that the synthetic impedance is at least 2 Ω.

•The setting of the POWER MODE switch varies according to the speaker impedance. Slide the POWER MODE switch to the HI-CURRENT position if the impedance is from 2 Ω to less than 4 Ω, or slide it to the NORMAL position if the impedance is from 4 Ω to 16 Ω. The same setting is used for both amplifiers.

•When switching to the SYNC INV mode, the stopper over the MODE SELECT switch must be removed and you can find SYNC INV switch. Remove the stopper after checking that connections are correct.

Two Amplifier

MODE SELECT switch must be in MASTER position.

 

Connect to a car stereo.

 

For details, see the

SYNC OUT

“Connection Diagram”.

 

 

Connecting wire with RCA

 

pin plugs (sold separately).

1 Ω to 8 Ω

MODE SELECT switch

 

must be in SYNC position.

SYNC IN

1 Ω to 8 Ω

•Use speakers having an impedance from 1 Ω to 8 Ω.

•The setting of the POWER MODE switch varies according to the speaker impedance. See the “Setting the Unit” section for details. The same setting is used for both amplifiers.

11