Connecting the Speaker Wires

Connect the speaker leads and set MODE SELECT switch and POWER MODE switch to suit the configuration according to the figures shown below and the next page.

•When synchronously connecting two or more amplifiers in combination, only use these amplifiers. Do not mix these amplifiers with other amplifiers.

•When synchronously connecting two or more amplifiers in combination, set the gain control, subsonic select switch, cut off frequency control for LPF and bass boost control on the amplifier that has been set to MASTER with the MODE SELECT switch. These settings are inactive when set on an amplifier set to SYNC or SYNC INV.

CAUTION

 

 

 

Diagram A - Proper

 

Diagram B - Improper

 

4 Ω

4 Ω

2 Ω

2 Ω

Speaker

Speaker

Speaker

Speaker

2 Ω Bridged Mode

 

1 Ω Bridged Mode

 

Do NOT install or use this amplifier by wiring speakers rated at 2 Ω (or lower) in parallel to achieve a 1 Ω (or lower) bridged mode (Diagram B).

Amplifier damage, smoke, and overheating could result from improper bridging. The amplifier surface could also become hot to the touch and minor burns could result.

To properly install or use a bridged mode and achieve a 2 Ω load, wire two 4 Ω speakers in parallel with Left + and Right – (Diagram A) or use a single 2 Ω speaker.

If the synthetic impedance is from 2 Ω to less than 4 Ω, always make sure to set the POWER MODE switch to the HI-CURRENT position.

In addition, refer to the speaker instruction manual for information on the correct connection procedure.

Single Amplifier

 

 

MODE SELECT switch must

Connect to a car stereo.

 

 

be in MASTER position.

For details, see the “Connection Diagram”.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 Ω to 8 Ω

•Use speakers having an impedance from 1 Ω to 8 Ω.

•The setting of the POWER MODE switch varies according to the speaker impedance. See the “Setting the Unit” section for details.

êìëëäàâ NEDERLANDS ITALIANO FRANÇAIS DEUTSCH ESPAÑOL ENGLISH

10