Pioneer S-3EX manual Single-WireConnections, Bi-WireConnections, English, Amplifier rear

Single-Wire Connections

For single-wire connections, connect the mid-to-high- and low- frequency sections of the crossover network with the shorting link that was included with this unit, then connect the (+) wire from your amplifier to either red binding post and the (–) wire from your amplifier to either black binding post, as shown in below.

Amplifier (rear)

SPEAKERS OUTPUT

(Only one channel shown)

Shorting link connection

HF HF

LF

Speaker

Speaker (rear): Input panel

Bi-Wire Connections

In a bi-wiring connection, you independently plug in the speaker systems running from the amp to their respective high- and low- frequency plugs. This results in the CST driver and bass drivers being independently connected directly to the amplifier, offering you the freedom to optimize the cable type for each of the drivers. Connect one set of wires to the bottom set of binding posts (bass driver-specific network). Then connect a second set of wires to the top binding posts (CST-specific network). Next, connect both sets of wires to the appropriate terminals on your amplifier. Take care to connect both (+) wires to the (+) amplifier terminals and both

(–) wires to the (–) amplifier terminals, as shown below.

Amplifier (rear)

SPEAKERS OUTPUT

(Only one channel shown)

HF	HF
LF
	LF

Speaker

Speaker (rear): Input panel

9

English

En