Other Information
Attaching/Removing the Grille Cover
This speaker system comes with grille covers which may be attached and removed by:
1To attach the grille cover, line up the holes on the speaker with the inserts on the grill, and press firmly.
2To remove the grille cover, grab it by its bottom with both hands and gently pull toward you to separate the bottom part of the grille from the speaker.
3Slide your hands up to the middle section of the grille, and once again pull gently toward you. This will remove the middle section of the grille from the speaker.
4Finally, repeat this same motion for the top part of the grille, removing the grille entirely from the speaker.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces.
Specifications
Enclosure | 14. . . . .cm.(5. . | . . . . . . . | English | |
Mid tweeter | 1/2 inch) cone / 3 cm (1 3/16 inch) dome | |||
|
|
| (magnetically shielded) |
|
Configuration | . . . . . | . . . |
| |
Woofer | . . . . . | . . . | . . . . . . . . . . 16 cm (6 5/16 inch) cone x2 |
|
Nominal impedance | . . . . . | . . . | . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Ω |
|
Frequency response . | . . . . . | . . . | . . . . . . . . . . . . . . . . . . 30 Hz to 100 kHz |
|
Sensitivity | . . . . . | . . . | . . . . . . . . . . . . . . . . . . . 88.5 dB (2.83 V) |
|
Maximum input power . . . . | . . . | . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 W |
| |
Exterior dimensions . | . . . . . | 350 (W) mm x 1224 (H) mm x 541 (D) mm |
| |
13 3/4 (W) in. x 48 3/16 (H) in. x 21 5/16 (D) in. Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 kg/105 lbs. 13 oz.
Supplied accessories
Spike bases . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Mounting pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 types, 2 each Metal catch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Screw (for metal catch) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Grille . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Operating instructions
Specifications and design subject to possible modification without notice, due to improvements.
Magnetic shielding
This speaker system is magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set.
If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set.
is a trademark placed on a product with Pioneer’s Phase Control technology. This technology enables
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.
11
En
