Pioneer S-7EX manual Magnetic shielding, Cleaning the speaker cabinet, Specifications

Models: S-7EX

1 23
Download 23 pages 59.54 Kb
Page 5
Image 5

Removing the grille

1Loosen, then remove the finishing screws from the four corners on the front of the grille.

2After detaching the grille, remove the fastening

screws from the four holes on the front of the speaker.

Optionally, you can insert the supplied caps into the holes.

Do not use a screwdriver (or hex wrench) to tighten the screws. Overtightening could damage the speaker.

When not in use, store the screws with these operating instructions for safekeeping.

Magnetic shielding

This speaker system is magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set.

If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set.

Cleaning the speaker cabinet

With normal use, wiping with a dry cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces.

Specifications

Enclosure

Bass-reflex bookshelf type

 

 

 

(magnetically shielded)

 

Configuration

......................................................................

3-way

English

Woofer

18 cm (71/16 inch) cone 2

 

Tweeter

14 cm (51/2 inch) cone / 3.5 cm (13/8 inch) dome

 

Nominal impedance

6

 

Frequency response

34 Hz to 100 kHz

 

Sensitivity

 

89.5 dB (2.83 V)

 

Maximum input power

200 W

 

Exterior dimensions

 

 

 

.................................

820 (W) mm 291 (H) mm 425 (D) mm

 

 

325/16 (W) in. x 117/16 (H) in. x 163/4 (D) in.

 

Weight

 

39 kg / 86 lbs.

 

Supplied accessories

1

 

Speaker base

 

 

Speaker spikes (with attached nuts)

.............................. 4

 

Spike bases

4

 

Fastening screws (for grille)

4

 

Finishing screws (for grille)

4

 

Caps

 

10

 

Grille

 

1

 

Operating instructions

1

 

Specifications and design subject to possible modifica- tion without notice, due to improvements.

Real, natural wood is used in the construction of the speaker system cabinets. They feature a wonderful color and depth that is much more attractive than plastic veneers and similar materials.

No two pieces of natural wood are exactly alike. Keep this point in mind as you enjoy these speakers.

With the cooperation of AIR Studios, this speaker has been designated AIR Studios Monitor Reference.

is a trademark placed on a product with Pioneer’s Phase Control technology.

This technology enables high-grade sound reproduction through each component by improving overall phase matching.

5

En

Page 5
Image 5
Pioneer S-7EX manual Magnetic shielding, Cleaning the speaker cabinet, Specifications, Removing the grille