Appendix

Appendix

Troubleshooting

If you have problems operating this product, refer to this section. The most common problems are listed below, along with likely causes and solutions. If a solution to your problem cannot be found here, contact your dealer or the nearest authorized Pioneer service facility.

Problems with this product

 

Symptom

Cause

Action (Reference)

 

 

 

 

 

The power doesn’t turn on. This

Leads and connectors are incor-

Confirm once more that all connections are

product doesn’t operate.

rectly connected.

correct.

 

 

 

 

 

 

The fuse is blown.

Rectify the reason for the fuse blowing, then

 

 

 

replace the fuse. Be very sure to install a cor-

 

 

 

rect fuse with the same rating.

 

 

 

 

 

 

Noise and other factors are causing

Press the Reset button.

 

 

the built-in microprocessor to oper-

 

 

 

ate incorrectly.

 

 

 

 

The screen is too bright.

Picture quality adjustment of the

Adjust the picture quality. (Page 21)

 

 

display is not correct.

 

 

 

 

 

The display is very dim.

The vehicle’s light is turned ON, and Set “Dimmer” to “OFF”. (Page 21) “Dimmer” is selected on “ON”.

Picture quality adjustment of the display is not correct.

Adjust the picture quality. (Page 21)

No sounds of audio source are The volume level is low.

Adjust the volume level.

produced.

 

 

The mute is on.

Turn the mute off.

The volume level will not rise.

 

 

A speaker lead is disconnected.

Check the connection.

 

 

 

 

The person on the other end of the phone call cannot hear the conversation due to an echo.

The voice from the person on the other end of the phone call is output from the speakers and then picked up by the microphone again, creating an echo.

Use the following methods to reduce the echo:

—Lower the volume on the receiver

—Have both parties pause slightly before speaking

There’s no picture.

The parking brake cord is not con-

Connect the parking brake cord, and apply

nected.

the parking brake.

 

 

The parking brake is not applied.

Connect the parking brake cord, and apply

 

the parking brake.

 

 

The backlight of the LCD panel is turned off.

Turn on the backlight. (Page 21)

Nothing is displayed and the touch panel keys cannot be used.

The setting for the rear view camera

Select the appropriate setting for the rear

is incorrect.

view camera.

 

 

The shift lever was placed in [R]

Select the correct polarity setting for “Rear

when the rear view camera was not

Camera”. (Page 21)

connected.

 

Problems in the audio screen

 

 

 

Symptom

Cause

Action (Reference)

 

 

 

 

 

 

 

 

 

 

 

 

iPhone cannot be operated.

The iPhone is frozen.

Reconnect the iPhone with the iPhone cable.

 

 

 

 

An error has occurred.

! Reconnect the iPhone with the iPhone

 

 

 

 

 

cable.

 

 

 

 

 

! Press the Reset button.

 

 

 

 

 

 

 

 

 

 

 

26

 

En