TROUBLESHOOTING

Symptom

Possible Cause

Remedy

 

 

 

No video image, or image is

¥ VIDEO INPUT switch is set incorrectly.

¥ Set the VIDEO INPUT switch to select the

disrupted.

 

currently playing component.

 

¥ Connection cables are not connected properly,

¥ Connect correctly.

 

or are disconnected.

 

 

¥ Connectors or plugs are dirty.

¥ Clean away any dirt before connecting.

 

¥ Trim controls are set improperly.

¥ Adjust trim properly.

 

¥ Signal format of the input video source does not

¥ Select the hardware setupÕs system settings to

 

match the system setting selected during

match the format of the video signal for the

 

hardware setup.

input/output video components.

 

¥ The TV monitorÕs video signal format does not

 

 

match the system setting selected during

 

 

hardware setup.

 

 

¥ The TV monitorÕs input selector is not set to the

¥ Set the TV monitorÕs input selector to the type of

 

input type actually connected to the unit.

input connected to this unit.

 

¥ The TV monitorÕs component setting is set to

¥ Set the TV monitorÕs component setting to 525i

 

something besides 525i (interlaced).

interlaced).

 

 

 

The character pressed on the

¥ The keyboard connected to the USB connector

¥ Set the keyboard language setup to match the

keyboard is not entered.

does not match the setting selected during this

type of keyboard connected to the USB

 

unitÕs keyboard language setup.

connector.

 

 

 

No response when touch panel

¥ Touch panelÕs calibration is incorrect.

¥ Set calibration properly in hardware setupÕs

is touched.

 

touch panel setting.

 

 

 

Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and then on again.

ABOUT THE LCD SCREEN

¥Some monitors may display so-called Òhot pixelsÓ or Òdead pixelsÓ (constantly bright pixels or pixels that are permanently off). This is a phenomenon characteristic of such displays and is not considered a malfunction.

¥When used in cold regions, the screen may appear dark for a while after the power is first turned on. As the unit warms up with time, the screen will return to normal brightness.

¥Avoid exposing the monitor to direct sunlight, since reflected light may make the image difficult to view.

Regarding Copy Protection

Limitation on Effects

If an attempt is made to use DELAY, ECHO, ROLL or REV ROLL effects with the input of copy-protected contents to any of the channels, the audio and video will not be subjected to the selected effect (the function will be disabled even if a non-copy-protected input is selected in the effect channel).

Also, even when the input of copy-protected contents is stopped, and ROLL, REV ROLL effects are once more enabled, the monitor may display a black screen.

ABOUT MINIATURE FLUORESCENT TUBE TECHNOLOGY

The LCD screen is illuminated by internal miniature fluorescent tube technology.

¥Fluorescent tubes are rated for approximately 10 000 hours of use (lifetime may be shorter when the unit is used in cold regions).

¥When a fluorescent tube reaches the end of its lifetime, the screen will become darker, making it difficult or impossible to see displayed images. In this event, consult your dealer or service center for repairs.

Copy Protected Information Display

In the event copy protected contents are input to a channel, the channel monitor for that channel will display a message like that show in Figure 1.

In this event, if DELAY, ECHO, ROLL, or REV ROLL are selected, the message shown in Figure 2 will be displayed.

Fig. 1

Fig. 2

46

En