03 Connecting up
Connecting the speakers
A complete setup of six speakers (including the subwoofer) is shown here, but everyone’s home setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best for surround sound. If you’re not using a subwoofer, change the front speaker setting (see Speaker setting on page 30) to large.
Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative
Front Speakers |
| Center Speaker | Surround Speakers | |
L | R | C | SL | SR |
Use speakers with a nominal impedance of 8 Ω to 16 Ω .
R L | R L |
INPUT
Be sure to complete all other connections before connecting this unit to the AC power source.
Powered subwoofer
Speaker terminals
1Twist around 1/2 inch of bare wire strands together.
2Unclip the speaker terminal and insert the wire.
1/2 inches
3 Snap shut the speaker terminal to secure.
16
En
ª ·
