Pioneer S-HTD1, XV-HTD1 Connecting to your TV

10
En
Connecting Up2
1
AC INLET
TV/
VCR
DIGITAL
IN
VIDEO
OUT
S-VIDEO
OUT
AUX
SUB-
WOOFER CENTER
FRONT REAR
IN
OUT
IN
R
R
L
R
L
L
COAX
SPEAKERS
VOLTAGE
SELECTOR
240V
AM
LOOP
ANTENNA
FM
UNBAL
75
Ω
220-
230V
110-
127V
H
1
TV/
VCR
DIGITAL
IN
VIDEO
OUT
S-VIDEO
OUT
AUX
IN
OUT
IN
R
COAX
H
H
VIDEO
IN
S-VIDEO
IN
Supplied video cord
S-Video cord (not supplied)
1 Use the supplied yellow video cord to
connect the VIDEO OUT jack to a video
input on your TV.
Alternatively, you can use an S-Video cable (not
supplied) to connect the S-VIDEO OUT jack to an S-
Video input on your TV. S-Video should give you better
picture quality than using the standard VIDEO OUT.
•See S-Video Out on page 39 for how to change the
S-Video setting between S1 and S2 format.
2 Optionally: Use a stereo audio cord to
connect the audio outs of your TV (or
VCR) to the TV/VCR IN jacks.
This will enable you to hear the TV (or VCR) sound
through this system.
•If you want to connect both your TV and VCR, use
the TV/VCR IN jacks for one and the AUX IN jacks for
the other.
Placing the main unit too close to your TV may cause
interference, especially if you’re using an indoor
antenna. If you notice interference, move the unit away
from the TV.
Setting the TV System
The default setting of this player is AUTO, and unless
you notice that the picture is distorted when playing
some discs, you should leave it set to AUTO.
If you experience picture distortion with some discs, set
the TV system to match your country or region.
1 Make sure that the system is in standby.
2 Press SYSTEM SETUP.
The current TV system is shown in the display.
3 Use 5 or ∞ to change the TV system.
Switch between auto, ntsc and pal.
4 Press ENTER.
The system returns to standby power.
Connecting to your TV