15
TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution
Power LED is not on *Check if the Power Switch is in the ON
position
*Power Cord should be connected
No Plug & Play
*Check if the PC system is Plug & Play
compatible
*Check if the Video Card is Plug & Play
compatible
*Check if the D-15 plug pin of Video Cable
is bent
Picture is fuzzy *Adjust the Contrast and Brightness
Controls.
Picture bounces or a wave
pattern is present in the picture *Move electrical devices that may cause
electrical interference.
The power LED is ON (orange) but
there’s no video or no picture.
*Computer Power Switch should be in the
ON position.
*Computer Video Card should be snugly
seated in its slot.
*Make sure monitor’s video cable is
properly connected to the computer.
*Inspect monitor’s video cable and make
sure none of the pins are bent.
*Make sure computer is operational by
hitting the CAPS LOCK key on the
keyboard while observing the CAPS LOCK
LED. The LED should either turn ON or
OFF after hitting the CAPS LOCK key.
Missing one of the primary colors
(RED, GREEN, or BLUE) *Inspect the monitor’s video cable and
make sure that none of the pins are bent.
Screen image is not centered or
sized properly. *Adjust pixel frequency (CLOCK) and FOCUS
or press hot-key (AUTO).
Picture has color defects
(white does not look white) *Adjust RGB color or select color
temperature.
Poor brightness or contrast
*When the brightness of the screen lowers
after being used for a certain period and the
function of the display is affected, send it to
our authorized service center for repair.
Horizontal or vertical disturbances
on the screen
*Use win 95/98/2000/ME/XP shut-down
mode Adjust CLOCK and FOCUS or
perform hot- key (AUTO-key).