Planar SD2420W manual Product Use, Operating in 2D mode, User controls and OSD menu

Controls and LED indicator

Product Use
Operating in 2D mode
Your SD2420W unit can operate either as a
3D stereoscopic monitor or in the standard
2D mode. Converting to 2D viewing can be
accomplished by either turning off the power
to one of the monitors or by putting the
mirror into the locked upright position. To
move the mirror to the raised position, use
two hands to slide it up the mirror support
arms and then raise it until it drops into the
locked position. To lower the mirror, use two
hands to lift it out of the locked slot and then
lower it down onto the fine adjustment
screws.	StereoMirror in 2D mode

The mirror should not be forced down. This can break the glass and damage the mirror frame. The mirror must be pulled forward before lowering.

User controls and OSD menu

The two monitors have a power switch on the right side of the bottom bezel. The switch has a dual function: the control for turning the monitor on or off and the LED indicator of monitor power status. When the LED is green, the power is on. When the LED is amber, the monitor is in power-saving mode.

The Source button allows the user to select VGA or DVI input. The Menu (M), Auto Adjust (AUTO), left arrow (<), and right arrow (>) buttons can be used to control the

On-Screen Display (OSD) menu. Press the Menu button to access the OSD menu, make a selection among the main menus, or confirm functions. The left arrow button adjusts the brightness or functions within the OSD menu. The right arrow button adjusts the contrast or functions within the OSD menu. The Auto Adjust button serves as an exit key to return to the previous OSD menu.

User’s Guide 9