4.CONSOLE CONFIGURATION

On the rear panel, there is one console port for configuring the switch. The attached cable in the packing box is used to connect to PC’s RS232C port (COM1, or COM2). Following the instructions below to configure the switch.

4.1 CONNECT TO PC

RS-232 serial cable

Attach the RS-232 cable 9-pin female connector to the male connector on the demo board. Plug the other side of this cable to your PC.

Hyper Terminal

In Window 95/98, launch “HyperTerminal”, create a new connection and adjust setting as below:

Baud Rate:

19200bps

Data byte:

8 bits

Parity check:

None

Stop bit:

1

Flow Control:

No

Console Menu

Launch the new terminal you just set up, and then, turn on the Switch. See the following messages for successful connection.

FNSW-16/2400S User’s Guide

15