8. STATUS LED

The STATUS LED indicates the configuration status by:

-Green light flashing: The camera is powered on and works in normal mode.

-Orange-Redlight flashing: Indicates the camera cannot access DHCP within the network.

9.Privacy Mode Button

Press this button to enter the camera’s privacy mode; this makes the camera stop monitoring temporarily until it releases from the privacy mode.

10. Network Cable Connector

This RJ-45 connector is used to connect the 10Base-T Ethernet or 100Base-TX Fast Ethernet network (which should be Category 5 twisted-pair cable). The port supports the NWay protocol, allowing the camera to automatically detect or negotiate the transmission speed of the network.

11. DC Power Connector

The DC power input connector is located on the camera’s side panel, and is labeled DC 5V with a single jack socket to supply power to the camera. Power will be generated when the power supply is connected to a wall outlet.

12. Camera Stand

The camera stand allows you to place the camera on a flat surface, instead of hanging on the wall or installing on a tripod.

13