2. HARDWARE DESCRIPTION

This product series provide three different running speed – 10Mbps, 100Mbps, and 1000Mbps in the same switch and automatically distinguish the speed of incoming connection.

This section describes the hardware features of these Switches. For easier management and control of the switch, familiarize yourself with its display indicators, and ports. Front panel illustrations in this chapter display the unit LED indicators. Before connecting any network device to the switch, read this chapter carefully

There are following option module for expansion:

8-Port 10/100 auto-sensing Intelligent Switch Module 4-Port 100 Base-FX Intelligent Fiber Module Gigabit 1000Base-T Intelligent Switch Module Gigabit 1000Base-SX/LX Intelligent Fiber Module

2.1 Front Panel

The Front Panel of the MGSW-2402 Intelligent Switch consists of 24x auto-sensing 10/100Mbps Ethernet RJ-45 Ports, two optional expansion slots, and Console port. The LED Indicators are also located on the front panel of the Switch.

LED indicators

 

MGSW-2402 Switch front panel

 

 

 

 

 

MGSW-2402

 

 

PWR

Green

Lit on: Power on

 

 

Lit off: power off

Diag.

Red

Lit on: Alert and problem notice

100

Green

Lit on: the port run at 100Mbps

 

 

Lit off: the port run at 10Mbps

LNK/ACT

Green

Lit on: the connection is good.

 

 

Blink: The port is receiving or transmitting data

FDX/ COL

Yellow

Lit on: the port run at full-duplex

 

 

Blink: Half-Duplex/ Collision

 

 

Off: Half-duplex or not connected

2.2 Rear Panel

The rear panel of the Switch indicates an AC inlet power socket and an on/off switch which accepts input power from 100 to 240VAC, 50-60Hz.

MGSW-2402 Switch rear panel

- 6 -