4.2.8 stack--STACK Management Commands

These commands allow configuring the Stack Parameters. The screen in Figure 4-60 appears.

Figure 4-60: Stack Screen

4.2.8.1 stack show

This command allows to viewing the current status of stack function. The screen in Figure 4-61 ap- pears.

Figure 4-61: Stack show Screen

4.2.8.2 stack <on [-A-m-s]off>

This command allows enable the stack function. There are four available options from the “Stacking State”. The options and descriptions are shown as below:

Disable: disable stack function.

Auto select: choose this stack mode. It will assign the Switch with minimum MAC address as the Master device.

Master: choose this stack mode. It will allow user assign one specific Switch as the Master device.

Slave: choose this stack mode. It will allow user assign one specific Switch as the Slave device.

70