(Peer-to-Peer mode) VIP-157S Port 1 to Port 2 communications
Supposing one VIP-157S connects to two telephones, just pick up phone 1 and dial ‘192*168*0*1**5062’, phone 2 will ring.
Analog telephone sets are connected to the phone (RJ-11) ports of VIP-157S respectively
192.168.0.1
1001 | | | | | | | 1002 | | | | | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
1 | | 9 | | 2 | | * | | 1 | | 6 | | 8 | | * | | 0 | | * | | 1 | | * | | * | | 5 | | 0 | | 6 | | 2 | | # |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
Operation steps:
a)Pick up the telephone set on VIP-157S port 1, and you should be able to hear the dial-tone
b)Press the keypad: 192*168*0*1**5062# shall be able to connect to the VIP-157S port 2
c)Then the telephone set in VIP-157S port 2 should ring. Please repeat the same dialing steps on port 2 to establish the first voice communication from VIP-157S
yIn default machine operation, the VIP-157 is at PSTN mode. If you want to make an IP call, press the “*” key to switch to IP Phone mode. For VIP-156, no need to press the star “*” key in advance.
yIf the IP address of the remote calling party is known, you may directly make calls via its IP address and end with a “#”.
yIf the ATAs are installed behind a NAT/firewall/IP sharing device for Peer-to-Peer VoIP application, please make sure the NAT device support SIP applications, and suitable settings should be applied to the NAT device to enable the SIP communications before making calls
y[VIP-157S] in PLANET ATA series products, to connect to remote ATA, press the keypad in the following sequence to connect to the remote VIP-157S port 2: [remote ATA IP address]**5062, for example:
192*168*0*2**5062
