Chapter 5 WLAN Planning
5.1 Site Survey
The following operating and environmental conditions must be considered when performing a site survey:
Data rates – The sensitivity and the radio range are inversely proportional to data rates. Therefore, the maximum radio range is achieved at the lowest workable data rate, and a decrease in receiver threshold sensitivity occurs as the radio data rate increases.
Antenna type and placement – Proper antenna configuration is a critical factor in maximizing radio range. As a general rule, the radio range increases in proportion to antenna gain and height.
Physical environment – Clear or open areas provide better radio range than closed or filled areas. Clear line of sight (LOS) is required to establish a good and reliable wireless link.
Obstructions – Metal shelving or a steel pillar can hinder devices. To avoid placing these devices in locations where those obstructions are between the sending and receiving antennas.
5.2 Data Rate
The table below is the referenced data about over what range the
| Maximum Distance | Maximum Distance |
| (17dBi Antenna) | (23dBi Antenna) |
|
|
|
6 Mbps | 17.72 KM | 30.79KM |
|
|
|
9 Mbps | 16.82KM | 29.36 KM |
|
|
|
12 Mbps | 16.07KM | 28.07 KM |
|
|
|
18 Mbps | 14.64KM | 25.60 KM |
|
|
|
24 Mbps | 11.66 KM | 20.26 KM |
|
|
|
36 Mbps | 8.21 KM | 16.85 KM |
|
|
|
48 Mbps | 3.72KM | 12.23 KM |
|
|
|
54 Mbps | 1.84 KM | 7.32 KM |
|
|
|
5.3 RF LOS (Line-of-Sight)
For the wireless communication, the
The first requirement is the
The following figure illustrates the concept of a good radio
- 22 -