Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WRT-416.

• Keep the wireless router as central in your work area as possible. Signal strength and speed fall off with distance.

• Higher is often better. For instance, set it up on the top shelf of a bookcase rather than the bottom one, if possible.

Prior to connecting the hardware, make sure to power off your Ethernet device and Wireless Router. Then follow the steps below to connect the related devices.

Step 1: Connect your computer to the LAN port of WRT-416 by using RJ-45 cable. Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch or a computer’s Ethernet port, and the other end to one of the LAN ports of your router.

Step 2: Assemble the antenna to WRT-416. Try to place them to a position that can best cover your wireless network. The antenna’s position will enhance the receiving sensitivity.

Step 3: Connect the power adapter. Connect the single DC output connector of the power adapter to the power jack on the side of the AP. Then plug the Power Adapter into an AC outlet.

Step 4: Power on the following devices in this order: HUB or Switch, router, and PCs

ONLY use the power adapter supplied with the WRT-416. Otherwise, the product may be damaged.

If you want to reset your WRT-416 to default settings, press the Reset button 5 second. Then release the button and wait for 10 seconds for rebooting.