show port port#

This command displays port-unique parameters for a telephony interface port.

show port

Syntax Description

port#

Zero-based number of the telephony port.

Configuring Port-Common Parameters

The ITG maintains two sets of port-common parameters, primary and secondary. Each telephony port chooses which of them to be used by specifying it in one of its port-unique parameters. Refer to command “set port port# port_cfg” on page 20 for details on how to choose port-common parameters for a telephony port.

The following sections describe commands for configuring port-common parameters. Commands for configuring port-common parameters share the same syntax as follows:

set port_cfg [sec] option [option] . . .

Where the optional key word sec, if entered, stands for configuring secondary port-common parameter. This key word may be omitted, if you are configuring the primary port-common configuration. For simplicity, commands described in the following sections only include those for configuring primary port-common parameters.

Commands for configuring port-common parameters are categorized into the following groups:

ŸCommands for configuring general port-common parameters that apply to all types of telephony interface port.

ŸCommands for configuring port-common parameters unique to FXO interface

ŸCommands for configuring port-common parameters unique to FXS interface

Configuration General Port-Common Parameters

The following sections describe commands that apply to all types of telephony interface port.

set port_cfg ans_wait

This command is used to set a wait-for-answer time limit on a telephony port. If the call destination does not answer within this period, the call is automatically terminated.

set port_cfg anw_wait seconds

Syntax description

seconds Value in seconds, ranging from 0 to 65534, or –1 or 65535 for forever.

Factory default

-1

Telephony Interface Port Configuration Commands

21