1 | 2 |
1.Plug handset lifter power cord into handset lifter jack on base. Push firmly into base.
2.Position handset lifter under the handset on your phone. Verify that the lifter is located on top of the telephone speaker. If not, you will need to attach the ringer microphone as described on page 22.
NOTE: Remove only a tiny piece of mounting tape backing to temporarily stick lifter into position; you may need to move it later.
1. Slide headset into charging cradle; the earpiece with the microphone goes into the cradle.
| 2. Gently press down on the headset |
| to ensure that headset is in correct |
| position. Amber charge indicator |
| light on base will flash while |
| charging and will change to solid |
1 | amber when fully charged. |
| |
2 | • 20 minutes = minimum |
| chargeto continue setup |
• 3 hours = full charge
1 |
|
2 | |
| ” |
6“
3 | IntelliStand™ |
| off |
| IntelliStand |
| on |
Set the IntelliStand switch to IntelliStand off
Set the IntelliStand switch to IntelliStand on (=) if you want the handset to automatically
pick up when you take the headset off the charging cradle.
The minimum recommended separation distance is shown above.
Important: Incorrect positioning can cause noise and interference problems.
8
9
