Amplifier Features Front Panel, Standby LED | Plinius Audio SB-301

AMPLIFIER FEATURES – FRONT PANEL

STANDBYERROR

FRONT PANEL LAYOUT SHOWING STANDBY AND ERROR LEDS

STANDBY LED

The Standby LED indicates when the amplifier has been put into standby mode by an external processor (connected to the remote trigger terminals described later). When the Standby LED is on, the external processor has muted the SB-301 and put the amplifier into power saving low bias mode.

ERROR LED

This LED on the right of the panel will flash only when an error condition has been detected by the SB-301 microcontroller.

6

Image 6

Plinius Audio SB-301 manual Amplifier Features Front Panel, Standby LED, Error LED

Contents

Page Serial Number Final Test Certified By Design Philosophy Contents Precautions Amplifier Features Front Panel Error LEDStandby LED Amplifier Features Rear Panel AM Plifier Configuration Selector Amplifier Configuration Selector ACS Input Terminals BALANCED/UNBALANCED Signals Mains SwitchOutput Terminals Ground Lift Switch Mains Power Cord IEC ConnectorRemote Trigger Terminals Installation and Operation Placement and VentilationMains Voltage Connection INPUT/OUTPUT Connection Rear Panel Showing Location of INPUT/OUTPUT Terminals Termination Quality BI-WIRINGXLR Stereo Phasing or Polarity Connecting the Mains Supply WARM-UP Period Important do not FIT a Fuse with a Higher Rating Error DetectionFuse Protection LED Brightness Control MAINS/LINE Fuse Loudspeaker Selection Specifications Index Contact Details