When an Indicator is Lit or Blinking
The indicators on the projector’s control panel lit or blink to notify of problems, as described below.
An indicator is also used to notify you of the currently set power mode (under normal circumstances). See “Power Cable Connections and Switching the Power On/Off” on page
STANDBY indicator
STATUS indicator
| Indicator status | What you should do | |
STATUS | STANDBY | When the power is on (Lit green) | It is time to replace the lamp. |
|
| Standby (Lit amber) | Replace with a new lamp cartridge. |
|
| Lit red |
|
STATUS | STANDBY | Blinks amber for 60 seconds, then lit | The lamp has reached the end of its service life.The power |
|
| amber | will no longer turn on. |
|
|
| The projector can be used for 100 hours after the lamp has |
|
| Lit red | reached the end of its service life. |
|
|
| Replace with a new lamp cartridge. |
STATUS | STANDBY | Lit red | The lamp cover is open. |
|
|
| The lamp cover is not properly mounted. Mount it properly. |
|
| Blinks red |
|
|
| (lit for 1 seconds/off for 1 seconds) |
|
STATUS | STANDBY | Lit red | The temperature is abnormally high. |
|
|
| • Refer to “About the Temperature Protector” below. |
|
| Blinks red |
|
|
| (lit for 0.5 seconds/off for 0.5 seconds) |
|
STATUS | STANDBY | Lit amber | The fan has stopped. |
|
|
| Unplug the power cable and contact a store that sells the |
|
| Blinks red | |
|
| (lit for 0.5 seconds/off for 0.5 seconds) |
|
STATUS | STANDBY | When the lamp has burned out | The lamp will not light. |
|
| during use | Wait at least 90 seconds, then turn the power back on. If the |
|
| Blinks amber for 90 seconds, then lit | problem persists, unplug the power cord and contact a store |
|
| amber | that sells the |
|
| When the lamp does not come on |
|
|
| from the start |
|
|
| Lit amber |
|
|
| Blinks red |
|
|
| (lit for 1 seconds/off for 1 seconds) |
|
Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect the power cable and contact your store of purchase.
Thermal Protector
When the temperature inside the projector becomes abnormally high, the STATUS indicator blinks red (0.5 seconds on/0.5 seconds off), the STANDBY indicator is a steady red, and at the same time the temperature protector operates and switches off the power of the projector.
Should this happen, please take the following actions.
1.Switch off the power and disconnect the power plug from the wall outlet.
2.Check the following matters and take the required measures.
When the projector is being used in a location that has a high ambient temperature, set it up again in a cool location. Check the outflow and intake holes and clean them if they are obstructed.
3.Wait about 60 minutes until the temperature of the projector drops.
If after having performed the above matters, the problem still has not been solved, please contact your store of purchase.
