PLUS Vision V-339 user manual When an Indicator is Lit or Flashing, Thermal Protector

When an Indicator is Lit or Flashing

The indicators on the projector’s control panel light or flash to notify of problems, as described below.

An indicator is also used to notify you of the currently set power mode. See “Power Cable Connections and Switching the Power On/Off” on page E-19.

STATUS indicator	STATUS
MENU
	DCM

STANDBY indicator

STANDBY
		E
		C
		R
	U
S	O

		A
	U
T
O

	Indicator status	What you should do
STATUS	STANDBY When the power is on (Lit green)	It is time to replace the lamp.
	Standby (Lit amber)	Replace with a new lamp cartridge.
	Lit red
STATUS	STANDBY	The lamp has reached the end of its service life. The power
		will no longer turn on.
	Flashing amber for 60 seconds, then lit
		The projector can be used for 100 hours after the lamp has reached
	amber
		the end of its service life.
	Lit red	Replace with a new lamp cartridge.
STATUS	STANDBY	The lamp cover is open.
	Lit red
	Flashing red	The lamp cover is not properly mounted. Mount it properly.
	(lit for 1 seconds/off for 1 seconds)

The temperature is abnormally high.

•The temperature protector has been activated. If the room tem-

STATUS	STANDBY	Lit red	perature is high, move the projector to a cool place. If the
			projector’s internal temperature is high, check the cooling fan’s
		Flashing red	ventilation slots and clean them if they are clogged.
		(lit for 0.5 seconds/off for 0.5 seconds)	• When the temperature protector is activated, the power turns
			off and in some cases will not turn back on immediately. In this
			case wait about 90 seconds, then try again.
STATUS	STANDBY		The fan has stopped.
		Lit amber
			Unplug the power cable and contact a store that sells the V-339
		Flashing red
			for repairs.
		(lit for 0.5 seconds/off for 0.5 seconds)
STATUS	STANDBY	When the lamp has burned out dur-	The lamp will not light.
		ing use	Wait at least 90 seconds, then turn the power back on. If the prob-
		Flashing amber for 90 seconds, then lit	lem persists, unplug the power cable and contact a store that sells
		amber	the V-339 for repairs.
		When the lamp does not come on
		from the start
		Lit amber

Flashing red

(lit for 1 seconds/off for 1 seconds)

Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect the power cable and contact your store of purchase.

Thermal Protector

When the temperature inside the projector becomes abnormally high, the STATUS indicator flashes red (0.5 seconds on/0.5 seconds off), the STANDBY indicator is a steady red, and at the same time the temperature protector operates and switches off the power of the projector.

Should this happen, please take the following actions.

1.Switch off the power and disconnect the power plug from the wall outlet.

2.Check the following matters and take the required measures.

When the projector is being used in a location that has a high ambient temperature, set it up again in a cool location. Check the outflow and intake holes and clean them if they are obstructed.

3.Wait about 60 minutes until the temperature of the projector drops.

If after having performed the above matters, the problem still has not been solved, please contact your store of purchase.

E-54