- - 29
b. Once all number and letters are entered
highlight Done and press ENTER
Figure 17. Renaming and Deleting Disc Titles
This section addresses basic playback for DVDs and
CDs.
Playing Back a Disc (DVD–CD)
1. Press the POWER button on the remote control
to turn the unit on from standby mode
2. Press the OP/CL button to open the DVD disk
tray loader
3. Place a DVD disk on the disk tray
4. Press the OP/CL button to close the DVD disk
tray loader. The player starts to play the first
selection recorded on the disc and continues
sequentially until the end is reached.
NOTE: In the event playback is not realized, check to
see if the parental controls are preventing playback.
Turn off the parental controls to realize disc playback
Angle Mark
1. From the Main Menu highlight “Setup Menu” and
press the Right arrow to select
2. Use the arrows to highlight “DVD Control” and
press the ENTER to select
3. Use the arrows to highlight “Angle Mark” and
press the right arrow to select
4. Use the Up and Down arrows to highlight desired
choice and press the ENTER to select
Language Selection
1. From the Main Menu highlight “Setup Menu” and
press the Right arrow to select
2. Use the arrows to highlight “DVD Control” and
press the ENTER to select
3. Use the arrows to highlight “Language
Preference” and press the right arrow to select
4. Use the Up and Down arrows to highlight desired
language and press the ENTER to select
Figure 18. Choosing Language Preference
Pausing Playback
1. Press the button any time during playback of
a disk. A “freeze frame” is created that stays on
the screen until you resume playing the disk.
Sound is muted during still playback.
2. To resume playback, press the button again.
Fast Forward/Reverse Playback (x2 – x8 Normal
Speed)
1. Press or buttons during playback. After the
fifth press, normal speed playback resumes.
2. Alternately, press the PLAY button to resume
normal playback at any fast speed setting.